Bantam 1.3 rocam I have install a new coil and still no spark on plugs


Asked by Oct 13, 2015 at 04:21 AM about the 2004 Ford Bantam

Question type: Maintenance & Repair

2 Answers


Make certain your crank shaft pickup is working.. Have someone crank the engine to see if a spark is present I usually put a spark plug wire on an old spark plug and lay the old plug on the engine. It's much easier to see a spark ... if no spark is there and the fuse is good then it may be the pickup... they are not expensive and most are easy to change

8 people found this helpful.

If the engine is cranking, but no spark at the plugs, check the starter relay. Its possibly has a short circuit in the starter relay.

1 people found this helpful.

Your Answer:

Ford Bantam Experts

  • #1
    Janus Welgemoed
  • #2
    Joel Mearns
  • #3
    AB Zaviour
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.