how do you replace hand brake cable for ford bantum 1988

Asked by Jul 06, 2016 at 11:34 AM about the 1988 Ford Bantam

Question type: Maintenance & Repair

1 Answer


To replace the handbrake cable on these bakkies, The cable is in two sections. The lever section is to the left of the steering column. Release the adjusting nut under the vehicle. To the left of the steering column the lever is secured with two bolts under the dash and I think a nut in the firewall in the engine compartment. Once these are removed the hand brake lever sould come out quite easily. As far as I can remember, the rear hand brake cable between left and right rear brakes is all in one piece. The rear brake drums would have to be removed to remove the cable.

Your Answer:

Ford Bantam Experts

  • #1
    Janus Welgemoed
  • #2
    Joel Mearns
  • #3
    AB Zaviour
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.