How do I install front drum brakes on my 100/6 Austin Healey?

Asked by Jul 17, 2017 at 07:14 PM about the 1958 Austin-Healey 100/6

Question type: Maintenance & Repair

1 Answer

86,015

I have not done the brakes on a 100/6 but in general you remove the dust cap on the wheel, remove the cotter key that holds the castle nut in place and then the nut, then remove the drum taking care to not drop the wheel bearing in the dirt. If the drum does not come off you may need to back off the brake shoe adjustment. Remove the springs that hold the shoes in place. Take a photo to help you put it back together or just do one side at a time. If the drums need turning your local auto parts store can probably help you. Install the new shoes and springs and reinstall the drums after re-greasing the bearings. Adjust the wheel bearing so that the bearings are tight and then back off a little bit so that the drum turns easily. Adjust the shoes until the shoes are tight and then back them off, a tiny bit of brake shoe dragging is OK. I would probably take it for a test drive and break in the shoes and re- adjust as needed. There are specialty tools available to help with the springs and the adjustments.

Your Answer

100/6

Looking for a Used 100/6 in your area?

CarGurus has 1 nationwide 100/6 listings and the tools to find you a great deal.

ZIP:

Austin-Healey 100/6 Experts

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.