I have a 1971 C10 truck. The motor sounds smooth but when I shift it into gear it doesn't want to take off and go very well. Happens even when I shift to other gears.

Asked by Buckshot270 Jul 07, 2015 at 12:09 AM about the 1971 Chevrolet C/K 10

Question type: Maintenance & Repair

I have just purchased this truck and I know very little of its history. The truck starts
easily on the first crank and sounds very smooth when idleing. It has a three speed on
the column that shifts fairly smooth.When the truck idles it does not smoke from but after
it is driven a few miles there is a white smoke that begins to start coming from the tail
pipe.

4,205

Bender0013 answered 8 years ago

White smoke is usually a bad head gasket or bad intake .check compression.

Mark helpful

Your Answer:

I have a 1971 C10 truck. The motor sounds smooth but when I shift it into gear it doesn't want to take off and go very well. Happens even when I shift to other gears. 1 Answer

I have just purchased this truck and I know very little of its history. The truck starts easily on the first crank and sounds very smooth when idleing. It has a three speed on the column that shifts...

1971 Chevrolet C/K 10

-

Maintenance & Repair
I have a 1971 C10 with a 3 speed on the column. I can put the shifter in all 3 gears and reverse but when I let out the clutch the truck does not want to move until i accelerate and increase the RPM. 3 Answers

As far as I know the clutch is good. There is no noise or odor that indicates to me the clutch is bad, but I don't know for sure it could be I'm no expert on clutches. How can I know for sure if it ...

Chevrolet C/K 10

-

Maintenance & Repair
I have a 1984 Chevy c10. I just recently got it started but it just seemed to die after a few seconds.. It helps when I pump the gas but it still won't run long enough to put it into gear and drive.. 2 Answers

I'm only 16. Its my first truck and idk a whole lot but I think ik quite a bit for my age.. The truck has a 350 in it with 42k miles on it.. Any help would be greatly appreciated!

1985 Chevrolet C/K 10

-

Maintenance & Repair
My truck won't move when I put it into gear. 2 Answers

I have a 77 chevy c10 with a turbo 400 tranny it won't go in gear when I put it into drive and makes a humming sound but if I put out in L1 it moves just fine and if I go into drive once I get mov...

1977 Chevrolet C/K 10 Custom Deluxe

-

Maintenance & Repair
I have a 1971 C10 with a 3 speed on the column. I can put the shifter in all 3 gears and reverse but when I let out the clutch the truck does not want to move until i accelerate and increase the RPM. 3 Answers

I am asking this question again to clarify my first question. My question wasn't clear what I intended to say was that I have to accelerate and increase to a very high RPMs in order for the truck to...

1971 Chevrolet C/K 10

-

Maintenance & Repair

Own this car?

Share your experience with others.

1971 Chevrolet C/K 10

Write a car review

Review another car

Used Chevrolet C/K 20

23 listings

Used Chevrolet Camaro

599 Great Deals out of 9,593 listings starting at $2,000

Used Chevrolet Corvette

703 Great Deals out of 12,046 listings starting at $3,200

Used Chevrolet Blazer

676 Great Deals out of 15,779 listings starting at $15,988

Used Chevrolet C/K 30

3 listings

Used GMC C/K 1500 Series

32 listings

Used Ford F-100

121 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I have a 1971 C10 truck. The motor sounds smooth but when I shift it into gear it doesn't want to take off and go very well. Happens even when I shift to other gears.

1 Answer

Your Answer:

Own this car?

Share your experience with others.

Shortcuts

Search Chevrolet C/K 10 Questions

CarGurus Experts

Know more, shop wisely

Related Models For Sale

Used Cars for Sale

I have a 1971 C10 truck. The motor sounds smooth but when I shift it into gear it doesn't want to take off and go very well. Happens even when I shift to other gears.

1 Answer

Your Answer:

Related Questions