I have a 67 c10 and I think the guy I bought from said that someone put a 350 in it, But I need to know what oil to use if I don't know what camshaft I have?

I have a 67 c10 and I think the guy I bought from said that someone put a 350 in it, But I need to know what oil to use if I don't know what camshaft I have? 4 Answers

i need to know what it takes to swap a 700r4 trans and install a th400 1 Answer

1985 chevy c10 pu short wheel base

I have a 1971 C10 with a 3 speed on the column. I can put the shifter in all 3 gears and reverse but when I let out the clutch the truck does not want to move until i accelerate and increase the RPM. 3 Answers

As far as I know the clutch is good. There is no noise or odor that indicates to me the clutch is bad, but I don't know for sure it could be I'm no expert on clutches. How can I know for sure if it ...

I have a 1984 Chevy c10. I just recently got it started but it just seemed to die after a few seconds.. It helps when I pump the gas but it still won't run long enough to put it into gear and drive.. 2 Answers

I'm only 16. Its my first truck and idk a whole lot but I think ik quite a bit for my age.. The truck has a 350 in it with 42k miles on it.. Any help would be greatly appreciated!

I have a 1971 C10 with a 3 speed on the column. I can put the shifter in all 3 gears and reverse but when I let out the clutch the truck does not want to move until i accelerate and increase the RPM. 3 Answers

I am asking this question again to clarify my first question. My question wasn't clear what I intended to say was that I have to accelerate and increase to a very high RPMs in order for the truck to...