my ford falcon 4lt engine just guts out after a while of driving. then i have to put it of and wait a minute or two then it starts again un till it does it again.when it runs it runs so smove.

Asked by Aug 13, 2017 at 04:23 PM about the 1996 Ford Falcon

Question type: Maintenance & Repair

1 Answer

655

This sounds like an Aussie EF Falcon. Check the connection to the PCM. There should be a plastic cap over the top of the PCM (Power Train Control Uint) located under the dash to the left of the glove box against the A Pillar. From my own experience moisture gets in between the plug and the contacts to thee PCM. Ign key out, Remove the cover. A star point screw holds the strap securing the PCM. Use a 10mm spanner to loosed the plug and clean the rubber seal and the seal at the bottom of the EECV PCM connector. Don't spray any lubrication oil. Leave them dry and re-enstall . NEVER Undo the PCM plug with the ignition ON or on ACC as it could damage the PCM

Your Answer:

Ford Falcon Experts

  • #1
    Troy Witt
    Reputation
    580
  • #2
    MrBlueOval
    Reputation
    380
  • #3
    Thadius
    Reputation
    130
View All

Related Models For Sale

Used Ford Mustang
273 Great Deals out of 37,434 listings starting at $1,350
Used Ford Fairlane
74 listings
Used Chevrolet Camaro
233 Great Deals out of 27,296 listings starting at $2,077
Used Chevrolet Corvette
91 Great Deals out of 15,032 listings starting at $3,620
Used Ford F-150
2,280 Great Deals out of 208,575 listings starting at $1,300
Used Chevrolet Impala
369 Great Deals out of 25,578 listings starting at $950
Used Ford Thunderbird
20 Great Deals out of 1,066 listings starting at $6,498
Used BMW 3 Series
856 Great Deals out of 31,256 listings starting at $1,250

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.