can I hard wire in brake and rear blinkers lights
the back lights won't work and nether
at blinkers .so I was wondering it I
could hard wire in the lights somehow
That's called being a hack Don't do it, check power from the switch, check operation of flasher. Here's a wiring diagram to help you do it correctly
ok thank you
it's all fried out now what
under the dash on right side of steering wheel
Define fried out, wires burnt? if so you may have to get a hold of some junk yards out west and find a replacement harness or if you can remove the old one and rewire the bad section.
I am rewiring as of this morning and I have tail lights and running lights but no blinkers and can't seem to find the spot cot connect power to to get them on and dose the car cone with back up light,originally
The back up lights are controlled with a switch usually combined with the neutral safety switch either on the column or if you have a floor shifter it's on the shifter mechanism. The power for the turn signals (from the fuse box) is routed through the turn signal switch and then out to the flasher and from there to the taillights
Looking for a Used Maverick in your area?
CarGurus has 9 nationwide Maverick listings and the tools to find you a great deal.
Search Ford Maverick Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Ford Maverick Experts