Maintenance & Repair Questions

  • Newest
  • Recently Active
  • Unanswered
Skidmora
0

Ford Explorer Issues

My 2011 Ford Explorer makes a 'clunk' noise when begin put in gear and shakes when accelerating from a stopped position. What is this? Going back to Ford dealer tomorrow for the 5th time.

402 views with 5 answers (last answer 2 years ago)
K-lo Doe
5

Change Crankshaft Position Sensor

I replaced the crankshaft position sensor on my 2000 Audi a6 with 2.8 engine. Now making loud screeching noise when running. I changed nothing else and was running smooth before that. Any suggestio...

1,561 views with 6 answers (last answer about a year ago)
jacknick
0

A/c Compressor Will Not Engage

a/c compressor will not engage, freon is good, put a new cycle switch on and checked fuses "all good". I can "jump" the cycle switch plug and the compressor will come on and the a/c works fine. I ran ...

1,624 views with 1 answer (last answer 2 years ago)
fscopilot
0

Van Will Not Start.

If you don`t hear sound from the fuel pump in the tank, with the key on, and the engine will not start, but the fuel gage is working, on front and rear tank postion, is the fuel pump bad ? Also on a 1...

1,878 views with 2 answers (last answer 2 years ago)
rsharp254
0

Oil Pressure 'guage' Going Up And Down While Driving

I have a '05 Trailblazer with 175K miles on it and today while driving home the warning light came on to ck. the guages. Looked over and noticed the Oil guage went from the average of 40 down to 0 an...

2,960 views with 1 answer (last answer 2 years ago)
nitaboobmwx5
0

Bmx X5 2003

Remote on my key stop working, now my key will not lock or unlock the doors ,key hole on the driver door seems to be stripped, got locked out the truck, roadside had to come literally had to break in ...

1,336 views with 5 answers (last answer 2 years ago)
Brettski23
0

Installing A New Timing Belt, Need Diagram And Step By Step Instruction. Wh...

Greetings: I have a 1986 Celica GT Coup. I have the new Tensioner and Timing Belt but need the instructions and diagram to install them, and adjust the timing afterwards. Where can I find said materi...

511 views with 2 answers (last answer 2 years ago)
dustin_leo92
5

Drive Shaft On My 89 Ford F150...

im having a drive shaft problem on my truck. it keeps throwing it. and i cant figure it out. any help willl be apreciated.

176 views with 3 answers (last answer 2 years ago)
David Scott
355

Has Anyone Used The Gatorback Coatings To Repair The Faded Plastic On Their...

Has anyone used the gatorback coatings to repair the faded plastic on their avalanche? If so how did you apply it and how did it come out? I've been looking at getting it from Gatorbackcoatings.co...

528 views with 5 answers (last answer about a year ago)
mr19th
0

Help With The Fuel Filter Replacing In A 2003 Jeep Liberty?

Before I start, this is for a 2003 Jeep Liberty V6 3.7-Liter truck. I have been told that my fuel filter needs to be changed and it is located in the rear/driver's side of the car. Here are the dire...

2,615 views with 4 answers (last answer 7 months ago)
buckpieper
0

My 2001 Saturn L100 Has No Power. It Starts Fine But When I Give It Gas To ...

Car starts and idles ok. when i put it in drive and give it gas, it will barely pull itself..

294 views with 1 answer (last answer 2 years ago)
MichaelC
0

How Do I Replace Heater Core In My 1988 Dodge Dakota

heater core leaks

390 views with 2 answers (last answer 10 months ago)
MichaelC
0

How Do I Remove Dash From 1988 Dodge Dakota

196 views with 1 answer (last answer 2 years ago)

Favorite this topic

Subscribe to Maintenance & Repair questions.

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 67,700
#2 dandyoun
dandyoun
Reputation 46,420
#3 tenspeed
tenspeed
Reputation 38,990
View All