Ford LTD Crown Victoria Questions Maintenance & Repair

  • Newest
  • Recently Active
  • Unanswered

Automatic Transmission Does Not Shift As Properly As Before After Filter Ch...

Recently I had the transmission filter and some fluid changed on my '90 LTD Crown Victoria. Since this filter change the transmission does not shift as properly any more as before - particularly when ...

97 views with 5 answers (last answer 4 months ago)

Why Is The Ignition Warning Chime Ringing So Quietly ?

Today I noticed that there is something wrong with the ignition warning chime on my '90 LTD Crown Victoria. When turning the ignition key to ON, the chime starts ringing for a few seconds. BUT it is n...

55 views with 1 answer (last answer 4 months ago)

Bad Acceleration After Replacement Of Cylinder Head Gaskets

Both cylinder head gaskets were replaced recently on my '90 LTD Crown Victoria because of oil leakage. During re-assembly I decided also to replace the fuel injectors - although the engine was running...

87 views with 7 answers (last answer 4 months ago)

Why Won't My 1984 Crown Victoria Hold It's Idle?

It has the 302 engine which I have no problem starting when cold but after it's been running for a while I have to keep the accelerator depressed when stopping at a red light or else the engine dies d...

149 views with 4 answers (last answer 6 months ago)

How Does The Ford Seat Belt Restraint System Work ?

None of my seat belts is getting blocked - not even when pulling them as fast as possible. Is this due to bad seat belt retractors or does Ford use a special restraint system to activate seat belts (e...

38 views with 2 answers (last answer 6 months ago)

How Do You Get Power To The Fuel Pump On A 1985 Ford Crown Vic Every Electr...

I have been from the in tank fuel pump to the distributor replacing all the electrical components along the fuel system and still have no electrical current going to the fuel pump. what is next to loo...

96 views with 3 answers (last answer 5 months ago)

Why Is My 83 Crown Vic Wasting Soooo Much Gas

I just filled the tank up the day before yesterday and I'm at 1/2 a tank already help me please

47 views with 1 answer (last answer 5 months ago)
Fred Lovinglife

Why Do My 91 Crown Vic Jerks When Driving And Goes Slow N Jerk Up Hill?

i have changed egr valve, fuel filter. transmission filter, solinoid, and tps please help its fustrating me,,,,,thank you

47 views with 2 answers (last answer 4 months ago)
Dennis German

What Is Wrong With My 1985 Ltd Crown Vic

I have changed the altenator, distributor, spark plugs/ wires, fuel filter, new battery, and the coil. the car cranks over but will not start. what should i change next.

70 views with 6 answers (last answer 4 months ago)
Joshua Humlie

When I Drive My 1988 Ford Country Squire After It Warms Up It It Stalls Out...

5.0 302 v-8, I am trying to figure the most likely problem so I can get the right part to fix the problem

50 views with 2 answers (last answer 3 months ago)

How To Clean Carb

my 1985 Crown Victoria has sat for about 6 years; I have the fuel pump working, and fuel to the CFI carb, but doesn't seem to get to the engine; probably some varnish in the system?

23 views with 1 answer (last answer 3 months ago)
Kristopher LaDuke

Wht Would Cause The A/c To Blow Warm At Best Even After A New Compessor Was...

I after doing so I remembered I ws supposed to have the system vaced and recharged so I had that done and it still only blows warm to barely cool. now its not blowing at all. Is there just a possible ...

Cody Heiford

Possible Injection Problems ,

Hi guys , my 85 crown Vic starts and runs great when cold , as soon as it warms up it won't idle as it should then cuts out , pops back though the exhaust on light throttle and the over run , i have...


My Moms 1988 Ltd Will Not Grt Gas To The Carbartor

my brother discovered a fuel leak and replaced it with a rubber line, then after wards the car would not start

Patricia Davis

What Is The Spindle Nut Torque Specifications On A 1989 Crown Victoria

Most spec guides states 221/300 ft lbs. So am I to assume you can torque the spindle nut to any number in this range?

1 2 3 next

Favorite this topic

Subscribe to Ford LTD Crown Victoria Maintenance & Repair questions.

Search Ford LTD Crown Victoria Questions

Ford LTD Crown Victoria Experts

#1 Tracy Hooks
Tracy Hooks
Reputation 180
#2 Michael Tutty
Michael Tutty
Reputation 150
#3 Tom Demyan
Tom Demyan
Reputation 70
View All

Related Models For Sale

Used Ford Crown Victoria"
27 Great Deals out of 1,449 listings starting at $1,750
Used Mercury Grand Marquis"
107 Great Deals out of 3,298 listings starting at $1,495
Used Ford LTD"
13 listings
Used Lincoln Town Car"
112 Great Deals out of 2,919 listings starting at $1,350
Used Ford F-150"
2,925 Great Deals out of 154,938 listings starting at $1,500