Ford Falcon Questions Any type
90s T Bird Front End
I have a 1967 Ford Falcon that was a 6 cyl car. I am thinking about putting a 90's TBird running gear in. I was just wondering if its possible measurement wise. I kind of like the idea of stoppin...
What Size Screws Are Used To Hold The Condenser And Points In Place In My 1...
rebuilding my distributor and the screws for the points and condenser are missing. need to know what size and thread,etc.
Door Rode Clip
Having problems with a door rode sliping out of the clip how do you remove and replace a new clip
Door Handle
Door handle on the driver side is not working .Inside door handle works . Is the problem with the lock rode .And how can you make adjustments
Hi There, My Ford Falcon BA XT 2005 Automatic Transmission. Having Problem...
Hi there, My ford falcon BA XT 2005 Automatic Transmission. Having problem is not shifting from 2nd gear to third i my mechanic have scan it he did not find any problem, he said all the four solin...
Red Wire On Ignition Switch Going To The Battery
The red wire on the ignition switch plug going to the battery needs to be replace .how do i remove old one from the plug
Capsula
I have a 1963 ford falcon under dash on the drive side there is a white cylinder about 3inches long attract to a wire is this a fuse for a radio?
Transmission Leaks
We just replaced all the seals in our 1963 Falcon 2 Speed transmission and it is still leaking badly. It appears to be flinging off the torque converter and is also dripping onto the pavement. Has any...
Power Steering Rack And Pinion
I have a 1933 Chev with a 1980 manual rack and pinion steering setup. I want power steering. I need to buy a 1980 power rack and pinion steering setup. Or is there something else that will fit it?
Soldering Or Connectors
Just wondering if it would be ok if I use a insulated connector on a wire from ignition switch instead of soldering have problems soldering thanks
How Do I Remove Windwing From My 1963 1/2 Falcon Futura
Windwing removal & installation
61 Falcon Problems Starting
I have replaced the battery,selonoid, starter generator, and wiring to all 3. When I try to start it onlymakes one click, any suggestions to what to do next? By the way headlights work.
Front Will Not Open From Outside
Front drive side door will not open from the outside . The door rode was disconnected from the clip how do you remove and replace the clip
Door Latch Retaining Clip
the rod from the outside door handle is disconnected from the door latch retaining clip. the old one still in place . does this mean that I need to replace door latch retaining clip.
63 Ford Falcon Front Wheel Bearing Replacement
I have a 63 ford falcon futura with a bad drivers front side wheel bearing. Ive worked on cars before but have never done a bearing could someone help me find out exactly which bearing I need to b...
Car Starts But Idles Rough Then Dies Shortly
I don't know too much about Cars but it has a 170 inline 6. it also has an auto lite 1100 recently rebuilt carb. When started it sounds just terrible but it'll run on its own, but will die within t...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.