Dodge Ram Pickup 2500 Questions Maintenance & Repair
- Recently Active
I am replacing the belt tensioner and the two idler pulleys. service manual gives torque specs for drive belt tensioner mounting bolt and tensioner pulley bolt but not for the two idler pulleys.
I repaired ground, gauge registered 1/4 tank until I moved the truck, & went to empty & stayed there, I have no current to fuel sender, except to fuelpump. I done the can/ bus test, on the 2006 I had ...
I have a 2005 dodge Cummins 5.9. It starts hard..about 20 sec roll over before it starts....it idles VERY rough...billows white smoke so bad you can not see behind the truck and after about 15 second...
Turned truck off and about 2 hours later, tried to start and the engine turned over, but would not fire up. I checked to make sure it had fuel at the injectors and it did. Are the injectors controll...
I've replaced the thermostat with a 190 and it still is running hot, my truck is a 2001 with 215000 miles, it's been bullet proof! I had the original Thermostat replaced at a garage about 205000 mil...
2001 Dodge Ram only runs when gas is poured down throttle body. Changed crankshaft position sensor, camshaft position sensor, coil and wires. Put in a rebuilt ECM. Checked and found 50 psi at fuel r...
Favorite this topic
Subscribe to Dodge Ram Pickup 2500 Maintenance & Repair questions.
Search Dodge Ram Pickup 2500 Questions
Dodge Ram Pickup 2500 Experts