Chrysler Concorde Questions Maintenance & Repair
Flashing "engine" Light Missing On Cylinder 3
Thursday car was running ok, but noticed a slight miss, Friday morning started my 2004 Chrysler concord limited LX it was missing something awful & engine light flashing & beeping, while driving ca...
Relays In The Door
I changed my fuel pump and everything and now my car won't start. Are there any relays in the door that go to the fuel system that will keep my car from starting? If u spray starting fluid in the ...
1998 Chrysler Concorde Wouldn't Shift Properly, Ran At High Rpms And The Sp...
My 1998 Chrysler Concorde wouldn't shift properly. I'd get to 45 mph and it wouldn't shift. It was running at high rpms and the spedometer started reading about 80 mph. I replaced the intake and ...
Where Is The Fuse For The Cruise Control On The Concord Limited ?
the dash indicator light for the cruise control does not come on and the cruise does not operate.
Where Is Rhe Oil Pump Sensor Located On The Car
Oil pump sensor
Our 2004 2.7 Concorde Sounds Like The Timing Chain Is Loud On Cold Starts O...
I have only heard the noise on cold starts. After it is started you can shut the engine off and start it again with no noise. No dash lights or codes show. It does not sound like lifters to me. Any th...
Best Way And Easiest To Replace Ac Heater Blend Door
My a/c only blows air not vold air. I was told today its not the belts or freon or compressor but the blend door. They also told me was working on passenger side only which when i tested it ...
My Speedometer Stopped Working And Also When I Drive Its Jerking
I stopped to run an errand..and before i shut my car off it was fine the speedometer was working, shut it off, turned it back on then drove a ways. realizing it was jerking when i was driving and my...
Seemingly Random Electrical Issues Connected?
I have no AC blower, no turn signals, no cruise control, and now my blinkers are malfunctioning (not blinking just staying on if they come on at all).
2003 Chrysler Concorde Won't Go Over 2000rpm
Changed the camshaft & crankshaft positioning sensors & it still won't go over 2000rpm. The car starts up fine-idles fine & runs fine until hitting approx. 2000rpm then it cuts off acceleration powe...
Wat Could Possibly Be Wrong
replaced passenger cylinder head and now it idle very high what could it be
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.