Chevrolet Questions General
Steering Wheel Noise Upon Turning
When I turn my wheels, I hear a rubbing noise in the car front and steering wheel.
1985 Silverado C10
I have a 1985 Silverado c10 pickup. An my rear driver side tire will spin in the air. But when on the ground an i put it in gear what move. But the other side moves in the air an on the ground. Do...
Turn Signal Brake Light
Have a strong light on the on the brake light on the driver's side also the turn signal on the driver side passenger side leak light on brake and turn signal
3.43 Vs 3.73 Rear End Gear
'm wanting to change gears from 3.43 to 3.73 because when towing these light loads( 6x12 open trailer or 18ft bass boat) my truck has a hard time maintaining hwy speeds, trans is constantly changing...
3.43 Vs 3.73 Rear End Gear
I'm wanting to change gears from 3.43 to 3.73 because when towing these light loads( 6x12 open trailer or 18ft bass boat) my truck has a hard time maintaining hwy speeds, trans is constantly changin...
3.43 Vs 3.73 Rear End Gear
Would the 373 gear be too much for my truck with a 4.8 engine? I commonly pull a 6x12 open trailer or 18ft bass boat.
1970 396 Motor In SS El Camino
I understand the 3 hp ratings for 1970 396. 325hp, 350hp, and 375.hp. I also read there was a 360 hp. for the 396. Was that a corvette rating or a misconception. . Thank you.
We Have A 2011 Silverado Truck The Choices For Driving Are P R N D M (it Is...
We have a 2011 silverado truck the choices for driving are P R N D M (it is my husband's truck) it is automatic so what does M stand for? He traded in his other truck for this one and I have never see...
I Have Never Seen A C10 Quite Like Mine.im Wondering If It Was A Rare Find ...
Its a 1970 c10 long bed 1/2 ton. Orange with white top it has upper chrome only along sides and came with 3 gas tanks. Nothing electric. No ac
Headlights
Lights are in the up possion how do I release them to close is there a bracket to get them down and where is it located
What To Do
I recently bought a car from a dealer on your site. Signed papers traded cars and then it broke 3 days laters, they came and picked it up and brought me my car that i gave to them as my loaner. T...
3.4 Engine Block Rod Caps
Put crankshaft put pistons in main bearings on torqued to specification rod bearing on torqued to specification not can not turn the crankshaft
Serch Eliminatetion
How do stop a serch I have saved
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.