Chevrolet C10 Questions Any type

  • Newest
  • Recently Active
  • Unanswered
wannabemechanic123
0

What Bolts/mounts Need To Be Undone To Pull A 305 Small Block Out Of A Che...

1986 Chevy C10? I see 2 motor mounts. Transmission and exhaust?? Sound about right?

26 views with 1 answer (last answer 3 months ago)
ocatrina
0

What Engine Can Replace The 250 L6 In My 1978 Chevy C10 Big 10 Pickup?

The manifold is warped on oem and I believe it is typical for that year. Is there another engine that could fit using existing mounts and transmission?

100 views with 1 answer (last answer 4 months ago)
Teodoro Resendez
15

Can I Make A 83 Chevy C10 To A 84 Chevy C10 Interior Wise As Steering Colum...

I bought a 83 c10 and like the 84 c10 dashboard and turn signal lever with cruise control and wind shield washer, could I change it by putting a new wire harness and a new column like the 84?

59 views with 4 answers (last answer 4 months ago)
chevyfreshwater
0

Silverado Not Running Well

Hi, ive got a problem with my 1985 silverado. it has a factory 305 and its not running to well. i'm sixteen and feeling like im getting in over my head. there are several problems with it. first, sh...

392 views with 1 answer (last answer 5 months ago)
mlo714
25

My 1972 350 Shuts Off Randomly Going Down The Road. After A Few Mins It Wil...

I just had the carb redone, new fuel lines and a inline filter. It has a HEI distributor for over a year now.

244 views with 6 answers (last answer 5 months ago)
Mark Nyberg
0

I Would Like To Convert My Front Drum Brakes To Disc Brakes. Can Anyone Tel...

need to know which car compatible for swap i heard a camero but which yr

95 views with 1 answer (last answer 6 months ago)
85chevy
0

Wat Could Be My Problem

I have a 85 chevy c10 pickup it has a 350 in it I jus rebuilt it had a slight skip on #7 cylinder now its worse and it seems to get even worse wen low on gas ive changed plugs, plug wires and rebu...

28 views with 1 answer (last answer 7 months ago)
PoppyD1959
0

Stopped Running And Won't Start

was running and shut off and now it will turn over but not start. I have replaced the Coil, Int Module, Pickup coil. Basiclie rebuilt the Distributor. still not running. It is an 84 chevy c-10 305

483 views with 4 answers (last answer 5 months ago)
Michael Davis
0

What Is A Good Replacement Rear End Higher Geared For This Truck

This truck has a 10 bolt low geared rear end 6 lug,need to change to a higher geared.has original rear I would like to just replace the chunk. Thanks Mike

627 views with 8 answers (last answer 8 months ago)
Michael Davis
0

Chevy C 10 Runs A Mile Or 2 Then Starts Missing And Dies,after A Few Minute...

This is a 1960 chevy c 10 it has a 350 bored 40 over , carburetor Manuel fuel pump and standard distributor w coil .it is not over heating water,fuel filter clean.when in shut down still has gas an...

102 views with 5 answers (last answer 5 months ago)
stephen8066
0

283 Motor Need Help

I took my 283 motor apart and put new head gaskets on it and got it all back to gether but now its not getting any fire.i put the distributer back in the same spot as i took it out off and i put a s...

28 views with 2 answers (last answer 8 months ago)
jaquemom
20

1969 Chevrolet C10 With V8 Engine Wont Start?!

We looked at the wiring, battery is fine, plenty of gas, new coils, new starter...what is wrong?

69 views with 3 answers (last answer 9 months ago)
briankc88
0

I Have A 1985 Chevy C10 5.0l Its A Fixer Upper. Was Running Really Good Now...

idles rough, but mostly dies at stop lights or anytime idling, while run as long as i give it gas. i bought the truck as a fixer upper had been sitting for a couple of years, change plugs and started ...

364 views with 3 answers (last answer 5 months ago)
Jeff Lollmann
40

Automatic Transmission Will Not Shift After Engine Swap

After installing and used motor in my 1979 Chevy pickup the automatic transmission will not shift out of first gear I have checked the kickdown linkage and the vacuum lines but still out of luck, any ...

354 views with 7 answers (last answer 10 months ago)
Tyeson75
0

I Have A 1979 Chevy C10

I don't fit under the dash like when I was kid....... I want to replace all the wiring, can I move the fuse box to a more accessible spot? I know this could require extending the wires to get them ...

85 views with 1 answer (last answer 9 months ago)
85chevy
0

Does Anyone Knoa What My Problem Is?

I have a 85 chevy pickup with a 350 engine in it I jus rebuilt it. It had a slight skip wen I got it runnin but now its worse and popping back through the mufflers

18 views with 2 answers (last answer 7 months ago)
mtatumalcoa
0

Why Wont Trans. Shift After Changing Intake

has no vacuum assist. worked fine til put aftermarket intake and carb on

11 views with 1 answer (last answer 4 months ago)
jmon12
0

1974 Chevy C-10 Starts Right Up, Drive It About 10 Miles Shut It Off. Let I...

74 c-10 350,4 barrel, electronic ignition

41 views with 1 answer (last answer 4 months ago)

Favorite this topic

Subscribe to Chevrolet C10 questions.

Shortcuts

Search Chevrolet C10 Questions

Chevrolet C10 Experts

#1 dandyoun
dandyoun
Reputation 80
#2 califcarson
califcarson
Reputation 70
#2 Peter Nichols
Peter Nichols
Reputation 70
View All