Chevrolet C10 Questions Any type

  • Newest
  • Recently Active
  • Unanswered
ocatrina
0

What Engine Can Replace The 250 L6 In My 1978 Chevy C10 Big 10 Pickup?

The manifold is warped on oem and I believe it is typical for that year. Is there another engine that could fit using existing mounts and transmission?

14 views with 1 answer (last answer 2 weeks ago)
Teodoro Resendez
15

Can I Make A 83 Chevy C10 To A 84 Chevy C10 Interior Wise As Steering Colum...

I bought a 83 c10 and like the 84 c10 dashboard and turn signal lever with cruise control and wind shield washer, could I change it by putting a new wire harness and a new column like the 84?

33 views with 4 answers (last answer 3 weeks ago)
Bob71Cheyenne
0

Will A 1968 C10 Grille Bolt Up To A 1971 C10?

I'm not a big fan of the 71 egg crate grille and really like the look of the 68 grille...I wouldn't mind a little fabrication to make the 68 fit.

chevyfreshwater
0

Silverado Not Running Well

Hi, ive got a problem with my 1985 silverado. it has a factory 305 and its not running to well. i'm sixteen and feeling like im getting in over my head. there are several problems with it. first, sh...

69 views with 1 answer (last answer 2 months ago)
mlo714
25

My 1972 350 Shuts Off Randomly Going Down The Road. After A Few Mins It Wil...

I just had the carb redone, new fuel lines and a inline filter. It has a HEI distributor for over a year now.

96 views with 6 answers (last answer about a month ago)
PoppyD1959
0

Stopped Running And Won't Start

was running and shut off and now it will turn over but not start. I have replaced the Coil, Int Module, Pickup coil. Basiclie rebuilt the Distributor. still not running. It is an 84 chevy c-10 305

110 views with 4 answers (last answer about a month ago)
Tyeson75
0

I Have A 1979 Chevy C10

I don't fit under the dash like when I was kid....... I want to replace all the wiring, can I move the fuse box to a more accessible spot? I know this could require extending the wires to get them ...

71 views with 1 answer (last answer 5 months ago)
stephen8066
0

283 Motor Need Help

I took my 283 motor apart and put new head gaskets on it and got it all back to gether but now its not getting any fire.i put the distributer back in the same spot as i took it out off and i put a s...

23 views with 2 answers (last answer 4 months ago)
Michael Davis
0

Chevy C 10 Runs A Mile Or 2 Then Starts Missing And Dies,after A Few Minute...

This is a 1960 chevy c 10 it has a 350 bored 40 over , carburetor Manuel fuel pump and standard distributor w coil .it is not over heating water,fuel filter clean.when in shut down still has gas an...

70 views with 5 answers (last answer about a month ago)
Michael Davis
0

What Is A Good Replacement Rear End Higher Geared For This Truck

This truck has a 10 bolt low geared rear end 6 lug,need to change to a higher geared.has original rear I would like to just replace the chunk. Thanks Mike

177 views with 8 answers (last answer 4 months ago)
85chevy
0

Wat Could Be My Problem

I have a 85 chevy c10 pickup it has a 350 in it I jus rebuilt it had a slight skip on #7 cylinder now its worse and it seems to get even worse wen low on gas ive changed plugs, plug wires and rebu...

19 views with 1 answer (last answer 3 months ago)
85chevy
0

Does Anyone Knoa What My Problem Is?

I have a 85 chevy pickup with a 350 engine in it I jus rebuilt it. It had a slight skip wen I got it runnin but now its worse and popping back through the mufflers

12 views with 2 answers (last answer 3 months ago)
Mark Nyberg
0

I Would Like To Convert My Front Drum Brakes To Disc Brakes. Can Anyone Tel...

need to know which car compatible for swap i heard a camero but which yr

37 views with 1 answer (last answer 2 months ago)
doverid
0

Changing From Idiot Lights To Factory Gauges, Can You Use The Standard Wiri...

I have a 77c10 with the idiot lights in the dash, Can I replace these with the gauges from the same year c10 that had the factory gauges and use the same wiring harness that is in the truck now?

mtatumalcoa
0

Why Wont Trans. Shift After Changing Intake

has no vacuum assist. worked fine til put aftermarket intake and carb on

4 views with 1 answer (last answer about a month ago)
jmon12
0

1974 Chevy C-10 Starts Right Up, Drive It About 10 Miles Shut It Off. Let I...

74 c-10 350,4 barrel, electronic ignition

22 views with 1 answer (last answer 3 weeks ago)
1 2 3 4 5 next

Favorite this topic

Subscribe to Chevrolet C10 questions.

Search Chevrolet C10 Questions

Chevrolet C10 Experts

#1 dandyoun
dandyoun
Reputation 80
#2 califcarson
califcarson
Reputation 70
#2 Peter Nichols
Peter Nichols
Reputation 70
View All

Related Models For Sale

Used Chevrolet Silverado 1500"
2,506 Great Deals out of 171,926 listings starting at $650
Used Chevrolet Camaro"
560 Great Deals out of 31,337 listings starting at $1,795
Used Chevrolet C/K 1500"
1,032 listings starting at $3,900
Used Ford F-100"
93 listings
Used Ford F-150"
2,930 Great Deals out of 154,936 listings starting at $1,500
Used Ford Mustang"
938 Great Deals out of 28,058 listings starting at $1,500
Used Chevrolet Corvette"
335 Great Deals out of 10,940 listings starting at $3,995
Used Chevrolet S-10"
66 Great Deals out of 1,871 listings starting at $1,599
Used Dodge Ram Pickup 1500"
832 Great Deals out of 14,604 listings starting at $1,900
Used Chevrolet Monte Carlo"
77 Great Deals out of 2,378 listings starting at $1,595