Chevrolet C10 Questions Maintenance & Repair

  • Newest
  • Recently Active
  • Unanswered
Tristiacon
0

Im Looking For A Fuel System Diagram For My 1985 Chevy C10 To Figure Out Ho...

I just bought a new Crate 350 LB 5.7L engine. Went from a stock 305 and now its pretty much all custom. I have a OEM mech fuel pump, but new edelbrock carb wants less than 6psi than the 10psi that t...

12 views with 5 answers (last answer 13 hours ago)
Kylekohler55
0

I Have A 67 C10 And I Think The Guy I Bought From Said That Someone Put A 3...

10 views with 4 answers (last answer about a week ago)
dinorogers
0

Turn Signal Flashes

changed signal switch turn signal flashes

7 views with 1 answer (last answer 2 weeks ago)
txgiant903
0

I Am Thinking About Buying A Ls1 For This 84 Chevy C10. What All Would I Ha...

8 views with 3 answers (last answer 2 weeks ago)
Buckshot270
0

I Have A 1971 C10 With A 3 Speed On The Column. I Can Put The Shifter In Al...

I am asking this question again to clarify my first question. My question wasn't clear what I intended to say was that I have to accelerate and increase to a very high RPMs in order for the truck to...

22 views with 3 answers (last answer 3 weeks ago)
Buckshot270
0

I Have A 1971 C10 With A 3 Speed On The Column. I Can Put The Shifter In Al...

12 views with 2 answers (last answer 3 weeks ago)
Buckshot270
0

I Have A 1971 C10 Truck. The Motor Sounds Smooth But When I Shift It Into G...

I have just purchased this truck and I know very little of its history. The truck starts easily on the first crank and sounds very smooth when idleing. It has a three speed on the column that shifts...

14 views with 1 answer (last answer 4 weeks ago)
Erik Herman
10

Starting / Running Issues 1986 Chevy C-10

Starts right up. drive it for a bit. good. stop somewhere and go to start and it just turns over and over. Go back several hours later and starts right up again. Fuel good. Spark good. Bad ignition sw...

38 views with 5 answers (last answer 3 weeks ago)
Joe Briden
0

Will A Starter From A 2003 Chevy Silverado 3500 8.1l Fit A 1969 C10 With A ...

I read that some of the newer chevy starters such as the one from a 2003 silverado will fit late model chevys but are better as they are high torque mini starters. GM stayed consistent with the moun...

11 views with 1 answer (last answer 2 months ago)
ChevyBeginner
0

85 Silverado Running And Head Lights Not Working

All my other lights work. Any ideas on what the problem is and where to start?

31 views with 4 answers (last answer 2 months ago)
Frogwisard
25

I Have Replaced The Battery And Alternator In My Truck,

i understand there is a clip that holds 2 wires and clips into the alt. on my truck the clip is not there. only 2 wires that have ends that slip over the posts. 1. what post is negative and which p...

olblue_70
0

How Do I Fix, No Side Marker,brake Or Running Lights When Pulling On The Li...

I have replaced the light switch but when I pulled the switch all the lights came on; turned switch off, turned it back on and no lights including dash lights

41 views with 1 answer (last answer 4 months ago)
Marty1976
0

Why Does My 78 C10 Shut Off When I Let Off The Gas? It Acts Like Its Starvi...

22 views with 1 answer (last answer 4 months ago)
Dave De La Cruz
0

Why Is Their Vacuum Coming From The Breather Tube

The heat riser is working.Its a 350 create engine .Vacuum is very hard coming in through the valve cover breather tube .the PVC is working fine. Its a four carb.with a edlebrock intake.

23 views with 8 answers (last answer 4 months ago)
Dustin Warren
0

Instrument Panel Lights Not Working Please Help. 1984 Chevy Scottsdale

I checked fuse and getting no hot from it even when I tryed to run a hot wire to the fuse it does nothing. 1984 Chevy c10 scottsdale

145 views with 7 answers (last answer 3 months ago)
El Guerrero Negro
0

What Do I Need To Do To To Replace My 3 Speed Tranny To An Automatic In My ...

24 views with 1 answer (last answer 3 months ago)
Chevytrucker
50

I Have A 1984 C10 With A Sbc 350 Let It Sit In Backyard 1 Year Or So Put A ...

When rev back fires smoke comes out carb oil level is fine noise is coming from 8 cylinder area (sounds like change in a dryer?) cylinder 8 lifters has a little play in them spark plug on 8 didn...

5 views with 1 answer (last answer 3 months ago)
19Guy57
0

Brake Peddle Almost Hitting Floor Board

Replaced front brakes on 1968 Chev 1/2 ton pickup. Bled all four lines as peddle was almost hitting floorboard before and fluid was low in master cyl. Still have very low brake peddle. Do I need ...

10 views with 3 answers (last answer 11 hours ago)
1 2 3 4 next

Favorite this topic

Subscribe to Chevrolet C10 Maintenance & Repair questions.

Shortcuts

Search Chevrolet C10 Questions

Chevrolet C10 Experts

#1 CaptPKelly
CaptPKelly
Reputation 100
#2 dandyoun
dandyoun
Reputation 80
#3 califcarson
califcarson
Reputation 70
View All

Related Models For Sale

Used Chevrolet Silverado 1500"
1,518 Great Deals out of 130,840 listings starting at $1,450
Used Ford F-150"
1,784 Great Deals out of 114,787 listings starting at $1,450
Used Chevrolet Camaro"
483 Great Deals out of 30,869 listings starting at $977
Used GMC Sierra 1500"
619 Great Deals out of 58,176 listings starting at $1,945
Used Chevrolet C/K 1500"
733 listings starting at $1,995
Used Ford Mustang"
658 Great Deals out of 31,355 listings starting at $1,399
Used Chevrolet Corvette"
253 Great Deals out of 11,345 listings starting at $2,950
Used Chevrolet S-10"
34 Great Deals out of 1,645 listings starting at $1,995
Used Ford F-100"
90 listings
Used Chevrolet Tahoe"
376 Great Deals out of 27,384 listings starting at $2,300
Used Jeep Wrangler"
361 Great Deals out of 41,555 listings starting at $1,800
Used Chevrolet Silverado 1500 SS"
3 Great Deals out of 74 listings starting at $7,988
Used Ford Bronco"
187 listings