Chevrolet C10 Questions Car Customization
- Recently Active
trying to change my manual trans to an automatic
I am currently running a 350 SBC with a 4 speed Muncie and 3.73 gears and would like a higher gear to make it a little better on the highway so I am not running 3,000 RPM at 60 MPH.
I bought a 83 c10 and like the 84 c10 dashboard and turn signal lever with cruise control and wind shield washer, could I change it by putting a new wire harness and a new column like the 84?
need to know which car compatible for swap i heard a camero but which yr
I bought the 290hp 350 from a GM dealership as a base model crate motor. I want more power. I don't want to have to mess with routing the exhaust for a turbo, so I'm thinking about adding a super...
I have a 350 and the fan sits about 3 inches lower and about 8 inches away from the radiator. Can't seem to find a shroud to fit and don't know if it would being so low and far away. Any help woul...
I am trying to install a 350 on my 65 chevy truck. It orginally had a six. I was told that the same mount from a six would work for v8 but the driver side mount won't line up to the truck bracket. The...
I have a donor 2006 Tahoe, I want to put the entire drive train in my 1968 C10. I also want to use the newer rear end and disk brake set up as well as the front spindles and brake set up. I will be co...
I bought a tilt wheel for 25 bucks from a guy who said it was out of a van and it was suppost to fit my 72 c10............Not so.. the one i got has a sort of D shape and my lower shaft is a round ...
What I would like to do is remove the inline six in my 1965 Chevy Pickup and install a Small Block or Big Block V8. I have a three on the tree and would like to keep that in place. Is there any V8's t...
Favorite this topic
Subscribe to Chevrolet C10 Car Customization questions.
Search Chevrolet C10 Questions
Chevrolet C10 Experts