Chevrolet Beretta Questions Any type

  • Newest
  • Recently Active
  • Unanswered
Saizo
0

Where Exactly Are The Crank Sensors On My 94 Chevy Beretta 3.1 V6?

1994 Chevrolet Beretta 3.1 V6 We are searching for the two crankshaft position sensors and the cam sensor. We are catching the devil trying to find this thing. One of them is supposed to be above the...

446 views with 2 answers (last answer 3 years ago)
pammym
0

What Price To Sell A Vechile

We are looking to sell 1990 yellow barretta pace car excellent condition what could we sell it for?

45 views with 2 answers (last answer 3 years ago)
goodegg
5

1989 Beretta Gt. Where Can I Find A Replacement Stock Steel Hood?

I've asked this question here before but the reply was to have one ordered through a body shop. Well, if a body shop can order a hood from someone, then I should be able to do the same. Who or what co...

80 views with 2 answers (last answer 3 years ago)
tysolambo
5

I Am In Vancouver Bc Canada 1990 Beretta Gt (v6 3.1l Mfi) Bright Red/grey I...

buy in states and ship here? does Chevrolet sell new parts for old models? AUTO wreckers have been no help... they either say No or they dont think so. (seat, dash, interior door with seat belt, - for...

109 views with 4 answers (last answer about a year ago)
LOU0245
0

Where Can I Get My Hands On A 1991 Berreta Gt, But In Mint Condition?

50 views with 1 answer (last answer 3 years ago)
zman1988
0

92 Baretta Idles Really Low And Dies When I Put It In Gear?

i checked the codes the oxygen sensor was bad and egr circuit codes. fixed the oxy sensor egr circuit went normal now theres no codes except diagnostic mode. feul filter pluggs wires are good. the pre...

155 views with 1 answer (last answer 3 years ago)
dsw8436
0

Looking For A Part

Looking for a shift cable number is 22576977

167 views with 1 answer (last answer 3 years ago)
Pillowtalk975
0

Anyone Know Why A 89 Beretta Gt V6 2.8l When Hot Has Hard Start...

Hi guys, I have a 89 berreta gt v6 2.8L that seems to not start when it gets hot. I already replaced the crank sensor, IVAC valve and ignition control module but had no success. I had my mechanic te...

1,042 views with 4 answers (last answer about a year ago)
mandos
35

96 Beretta Wont Start

!996 Beretta 3.1 V6. Engine quit on a hot day in traffic. Then after it cooled it ran fine. Then months later would not start. Replaced 4 of the plugs and wires, the crankshaft sensor, the throttle po...

540 views with 1 answer (last answer 3 years ago)
garys1990gt
0

Why Is My 1990 3.1 Gt Pumping Fuel Into The Air Cleaner Box?

When I start the car, fuel comes running into the air cleaner box. I hear a motor running by the head next to the fire wall, but don't know what it is. It also revs high and then low, then just dies i...

254 views with 1 answer (last answer 4 years ago)
EmilH
0

Fuel Filler Door Hinge

How do you take out the hinge out and replace it ?

467 views with 2 answers (last answer 3 years ago)
mhunike
10

O2 Sensors And Egr Valve

I have a 88 base beretta I am having bad gas mileage. I have a 2.0 4 cylinder. Wanted to know if the ecm should pick up o2 sensor if unhooked. My ecm is picking up trottle control and map sensor bu...

622 views with 4 answers (last answer 4 years ago)
paulsindy
10

1990 Beretta Indy Restoration Needed

I have a 90 indy, and am ready to restore, is there a place that I can purchase new parts. plastic beretta emblem between tail lights, door panels, steering wheel, seat covers, visors tail lights, and...

574 views with 8 answers (last answer about a year ago)
Dewane Wonser
0

Stalling

I have a 94 Baretta that will shut down after about 3 hours of highway driving, will restart and run about 2 minutes quarter mile or so, shuts down again, restart immediately, same thing, let it set a...

428 views with 4 answers (last answer 4 years ago)
jwalker28
0

Where Do I Find Parts For My 88 Berretta?

Im looking to re build my berretta and i do not know where to begin to look for parts i need the whole nine yards!

95 views with 2 answers (last answer 4 years ago)
TSabourin
45

Keys Locked Inside.

I was recently given a 95 Beretta GT. I got it home and parked it, ready to rip into it and get it going again. After getting out of the car, locking it, and closing the doors, I realized I only had t...

696 views with 2 answers (last answer 4 years ago)
momeeof2
25

Is There Any Way To Fix Stripped Caliper Bolt Holes On The Steering Knuckle...

No auto parts places around here sell them and the dumbass who tried to change the brakes before us stripped the caliper bolt holes totally. tried new bolts and the wouldn't tighten at all. Getting fr...

489 views with 2 answers (last answer 4 years ago)
goodegg
5

I Have An '89 Chev Beretta Gt With A Damaged Hood

I just bought an '89 Beretta GT always garaged, for $500. This car has 69,000 original miles on it and the body is near perfect. The hood is damaged and I need to replace it. Where can I find a suitab...

65 views with 2 answers (last answer 3 years ago)
69tatt2dup69
5

How Do I Dissassemble The Doors To Get At The Windows On My '93 Berretta Gt...

73 views with 4 answers (last answer 3 years ago)
blondeone
0

A/c In My Beretta Blows Hot Air. Compress Is 6 Yrs. Old And Freon Has Been...

158 views with 2 answers (last answer 3 years ago)

Favorite this topic

Subscribe to Chevrolet Beretta questions.

Shortcuts

Search Chevrolet Beretta Questions

Chevrolet Beretta Experts

#1 Dan McCaig
Dan McCaig
Reputation 90
#2 littlehorn
littlehorn
Reputation 60
#2 Tom Demyan
Tom Demyan
Reputation 60
View All

Related Models For Sale

Used Chevrolet Camaro"
535 Great Deals out of 31,804 listings starting at $977
Used Ford Fiesta"
228 Great Deals out of 16,746 listings starting at $5,000
Used Chevrolet Impala"
1,493 Great Deals out of 53,183 listings starting at $600
Used Buick Park Avenue"
5 Great Deals out of 600 listings starting at $1,990