Sign in | Register | My account |

Austin-Healey Questions Any type

  • Newest
  • Recently Active
  • Unanswered
JeffryM
0

About Seat Adjust For 62 Sprite Mkii

I should re-word my question about the seat adjusters. There is no L or R. What I need to know is should the adjusting lever be outside by the doors, or inside by the tunnel? Thanks Again

rogerthat
0

Can You Tell Me If This Is A 1962 3000

We found a casting number on the side of the block: AEC 881 We also found a tag on the left side of the engine: 29E/50-H2410 Also, a stamping on the rear end pumpkin: MCWCG. Not to sure about th...

24 views with 1 answer (last answer 7 months ago)
1960Healey
0

1960 Austin Healey 3000

A new front headlamp was installed and it works on low beam but goes out completely on high beam. Any suggestions or remedies? Thanks. DanL

171 views with 6 answers (last answer 7 months ago)
loveallcars
0

How Much Do Fiberglass Fenders Hurt The Value?

I'm looking into purchasing a 1963 3000 mkII,the steel fenders were replaced with fiberglass..all 4. They look great,the only way I could tell was there was no seam under the headlights.The car will b...

71 views with 1 answer (last answer 8 months ago)
grish
0

How Do You Install Front Brake Shoes On An Austin Healey 100-4?

I was told to attach the spring and then to pry the shoe on. I think this approach is almost impossible due to the strength of the spring. any suggestions? This is a 1953 100-4

140 views with 1 answer (last answer about a year ago)
Hinz
0

Top Speed

I recently purchased a 68 Healey sprite and was surprised and confused to find it tops out at about 60mph.... and that's red-lined in 4th gear. I am wondering if anyone can tell me what's wrong wi...

365 views with 3 answers (last answer about a year ago)
bruce1955
0

Where Is The I.d. Tag Locacted

645 views with 1 answer (last answer 3 years ago)
1gomango
0

Duel Master Cylinder

I want to pull out the old single master cylinder and replace it with a duel unit. Who sells a compatible unit?

394 views with 1 answer (last answer 4 years ago)
jll
0

Bj8 Quits Running

67 BJ8 that suddenly quits running after fill-up. Replaced most electrical and boiled gas tank. After a few hours, starts again. Any suggestions?

237 views with 2 answers (last answer 3 years ago)
Hinz
0

Hydraulic Fluid

I have a 67 sprite with the 1275 motor, I replaced the slave cylinder now I need fluid. Should I be using hydraulic fluid like for a jack? I tried power steering fluid but there's no pressure.

166 views with 1 answer (last answer 2 years ago)
JeffryM
0

On A 62 Sprite Mkii, Which Side Of The Seats Should The Adjust Be Located. ...

I am restoring this Sprite and am now at the point of putting this giant puzzle together, and find that I should have taken better notes. It seems the two front seats are interchangeable, thus I need ...

Favorite this topic

Subscribe to Austin-Healey questions.

Search Austin-Healey Questions

Austin-Healey Experts

#1 Fordtudor37
Fordtudor37
Reputation 10
#1 jamnblues
jamnblues
Reputation 10
#1 98DAK
98DAK
Reputation 10
View All

Austin-Healey Model Question Topics