All Car Questions

  • Newest
  • Recently Active
  • Unanswered
Paul Goodyear
0

Transmission Leak

I just replaced a new filler pipe and grommet in my 4L60E transmission and it still leaking around the grommet. I put 5 litres of tran fluid in the transmission pan so it shouldn,t be over full..I als...

635 views with 3 answers (last answer 3 years ago)
anno21
0

Brake Problems

I recently purchased a 1968 Mustang coup. I had major issues with the manual brakes so I replaced the brake booster, master cylinder, both front wheel cylinders, bled the brake lines and adjusted the ...

583 views with 3 answers (last answer 3 years ago)
Hockey71
0

Coil Issue?

so my eclipse will get up to temp and after a 20 drive I can shut it off and it won't want to start.Also just driving sometimesit'll drop to 0 rpms and shudder. I hooked it up to a computer and at fir...

193 views with 1 answer (last answer 3 years ago)
Renan Romney
0

Headlamps Won't Go Up

My Daytona has been sitting for a 1 1/2 years. Just put in a new battery. Everything works except for the headlamps. Do these run on vacuum?

345 views with 4 answers (last answer 3 years ago)
BuckeyeBubba
0

1996 Rl Stuck Valve Problem

Engine runs very rough like a plug miss-firing. Dealer said it was a stuck cylinder valve. Ran compression test, hear pop, ran ok for a week. Now same problem. Has low power, running like only ...

382 views with 4 answers (last answer 3 years ago)
chevyjones19
75

New Motor

im going to need a bigger motor eventually for my 84 any suggestions on what to pull it out of? I would like to find like a 409 or maybe a 427

21 views with 1 answer (last answer 3 years ago)
gladiator80
0

E85 In Corolla

Is it safe/ok to use e85 in my 2009 toyota corolla? The way that gas prices are going I thought that I would ask.

638 views with 2 answers (last answer 2 years ago)
doty
0

89 Ford Tempo Gl Turn Signals & Heater Fan Problems In The Ignition

I own a 89 Ford Tempo. When ever I place the key into the ignition I have to jiggle the key to get the turn signals & heater fan to work. But there are times when I don't have to start the car, but ju...

538 views with 4 answers (last answer 3 years ago)
mozea7
0

99 Legacy Outack - Belt Squealing - Is It The Timing Belt?

Howdy All - I'm the proud owner of a '99 Legacy Outback with just shy of 200K miles to its name. By no means an avid mechanic, I've recently taken both an idealistic and pragmatic interest in doing...

687 views with 1 answer (last answer 3 years ago)
James Ralston
305

1998 Camaro

What is a 1998 Camaro Z-28 worth? Its got the LS1, a Monster transmission, built to around 500hp at the crank. With 118,000 miles.

112 views with 3 answers (last answer 3 years ago)
havoc_33
240

Dodge Dakota Idling And Dying

My dakota will start then idle down and die. I can pump the gas and it will stay running but if i hold the peddle down or let off it will die. I have replaced the fuel pump, fuel filter, and the idl...

15,520 views with 33 answers (last answer about a month ago)
Bantam06
55

Why The Name Rocam Engine

Hi, I have a 1.3i Rocam engine, which is written on the tappet cover of the engine, i noticed that the tappet cover is also plastic? Could anyone please elaborate on this?

2,114 views with 2 answers (last answer 3 years ago)
jb65542
0

1996 Probe

I'm thinkingabout buying a probe with a v6 5 speed that the starter is bad on. The guy says there is sensor that won't let u push start it, is this true and if so is there a way to bypass it so I can ...

66 views with 1 answer (last answer 3 years ago)
hgrimm
0

Stock Wheels / Tires

My wife bought a 99 Avenger and it has 215-50-17 tires. Was that stock ? Also need a spare for it and don't know what to buy. Thanks

1,121 views with 2 answers (last answer 3 years ago)
stearman
0

Windshield Defrost Deflector Cover For Upper Center Section Of Dash

I have completely restored an 80 Corvette to include a very modified 383 block. The only piece left to complete is the deflector mentioned in the topic. My search through all the various parts manua...

530 views with 2 answers (last answer 3 years ago)
jeffp
0

Torsion Bar Hight Adjustment Bolts And Block

i recently tried adjusting my ride height on my 68. the fine thread adjustment bolt blew right past the threads and stripped out the retainer block. any ideas on where to find replacements?

604 views with 3 answers (last answer 3 years ago)
jawstech
10

Heater/ac Only Discharge At Floor Level Why?

hoses,diaphrams seem ok dash controls 5 years old .help please.

209 views with 2 answers (last answer 3 years ago)

Favorite Topics

Track new questions that interest you

or

Sign in

Ask a Question

CarGurus Experts

#1 Tom Demyan
Tom Demyan
Reputation 109,605
#2 dandyoun
dandyoun
Reputation 66,655
#3 tenspeed
tenspeed
Reputation 59,325
#4 tennisshoes
tennisshoes
Reputation 28,565
#5 littlehorn
littlehorn
Reputation 28,445
View All