Where is the cam shaft sensor in 2003 ZX2
I had a shop run a diagnostic tool on my car yesterday and found out I have a cam shaft sensor going bad. Where is the cam shaft sensor located in a 2003 Ford ZX2 and what should it look like? To replace it, I just need to unbolt it and then bolt on a new one correct?
I dont know about the car models but if it is a distributed engine it is below the CDi pick up coil in the distributor . If distributorless it is located near the cam shaft , it looks like a cylinder with a little hole in the middle
It is located on the front of the cylinder head near the ignition coil pack. Yes, replacing is a remove old and install new operation. Good Luck!