Nissan Altima ABS, VDC & Slip Lights on after tire rotation

I'm 99% sure it's your speed sensors. If they were in there doing a rotation, they could have clipped a sensor wire.... Grrrrr. That's why I dislike garages. Lol.

you can buy the sensors online for around $20 each. I would inspect it to see if you can see anything visually obvious. They aren't too bad to replace.

Thanks Mark. I am assuming this isn't a cheap or easy fix. I am wondering how much noise I should make at the garage that did the work.

The wires aren't where they can be clipped so that is unlikely. and if a wire is clipped it would've been on as soon as the car was turned on. Could be anything from low brake fluid or dirt on one of the wheel speed sensors. Check fluid level then get codes before you go replacing expensive sensors.

My ABS and the two traction lights came on about 100 miles after I had both rear brakes completely replaced. (Just came on randomly, not while braking.) Took it back in and they said it was a wheel sensor. So they charged me another $270 to replace the sensor. Same idiot lights came on before I even got off their parking lot. Then they said the computer needed to be "retrained" and in about 20 minutes they gave me the car back again. This time I got about 15 miles before the lights came back on AGAIN. Anyone know WTF is going on?

How you know which brake sensor to replace...brakes locked after accident

Brakes locked.which brake sensor I replace

Hola mi carro tiene encendida la luz vdc slip nissan altima 3.5l 2009