my 1991 automatic acura integra is not shifting into third or fourth gear(s) and the drive light in the dash isnt lighting up,is this a sensor problem or maybe the shift selenoid?

0

Asked by Paul Jan 08, 2013 at 02:09 AM about the 1991 Acura Integra 2 Dr LS Hatchback

Question type: Maintenance & Repair

4X4 switch clicks under dash (relay ?)but wont shift 1 answer

moveing control from 2 to 4WD clicks under the dash 5 or 6 times then stops but does not shift . is it the selenoid , and how do you check it bob

Ford F-150

-

Maintenance & Repair
I have a 96 Toyota Camry LE Auto 4cyl. Has a big problem upshifting. Now it shutters real bad going uphill, and the rpms go to 4 and 5k. I back off and slow down, soon having to pull over and stop. 1 answer

Once i shut if off and start it again it drives 50mph til the rpms start going high again. I stop and repeat. Do i need a new tranny or could it be the shifting selenoid or sensors?

1996 Toyota Camry LE

-

Maintenance & Repair
Not starting!!! 6 answers

Hello, I have a 1987 BMW 325e that has always had a problem that seldom happens. It happens hot or cold. The car will just not crank. I have put a fresh starter and selenoid but still does it once ...

1987 BMW 3 Series 325e

-

Maintenance & Repair
where is starter located in engine 1 answer

car will not start and it is not the battery we just had selenoid and sensors fixed in transmission x1week ago

2002 Dodge Intrepid SE

-

Maintenance & Repair
1989 244 DL auto overdrive 1 answer

will not shift ti overdrive, have replaced sending unit and serviced transmission with flush filter and new oil

1989 Volvo 240

-

Maintenance & Repair