Head Bolt Torque

0

Asked by philwr03 Dec 29, 2008 at 09:31 PM about the 1997 Chevrolet C/K 1500 Reg. Cab 6.5-ft. Bed 4WD

Question type: Maintenance & Repair

I just reinstalled my Vortec heads per specs. The final adjustments were degrees according to the length of the bolt. I understand this is for bolt stretch. But, being old school, is there a final torque that each bolt should be respectively?

7,095

- Report

John answered 3 years ago

what engine size do u have ill give u chiltons sequence

3 out of 3 people think this is helpful.

Mark helpful

0

- Report

philwr03 answered 3 years ago

I have reinstalled my heads and was advised to go 26, 44, 66 ft lbs for each pass. They have been on for about 3 months and seem to be doing ok. Any thoughts?

Mark helpful

Your Answer

What is the best procedure to replace a torque converter on a 96 k1500? 1 answer

Need to replace a torque converter on my 96 k1500. Have a whine in drive and have started to feel slip/delay when shifting from park to drive.

1996 Chevrolet C/K 1500 Ext. Cab 6.5-ft. Bed 4WD

-

Maintenance & Repair
Pinion Seal 3 answers

well i plan on changing the pinion seal on my truck(10 bolt)....I was told to make sure and not over tighten the nut that goes into the crush sleeve....The question im asking is about how tight should...

1994 Chevrolet C/K 1500 Reg. Cab 8-ft. Bed 2WD

-

Maintenance & Repair
water in oil 11 answers

water in oil

1998 Chevrolet C/K 1500 Reg. Cab 8-ft. Bed 2WD

-

Maintenance & Repair
how to replace flex plate 2 answers

1995 Chevrolet C/K 1500 Reg. Cab 8-ft. Bed 2WD

-

Maintenance & Repair
Horsepower and torque for 4.3L V6 3 answers

what are the horsepower ratings for this engine: GM 4.3L V6

1997 Chevrolet C/K 1500 Reg. Cab 6.5-ft. Bed 2WD

-

General