what is the pushrod order on the 3.1 engine

0

Asked by mpalm Nov 25, 2012 at 08:24 PM about the 1996 Chevrolet Beretta 2 Dr Z26 Coupe

Question type: Maintenance & Repair

995

- Report

Tom answered 5 months ago

the intake push rods are shorter than the exhaust push rods push rods should be put back in their original loction

Mark helpful

Your Answer

Where are the spark plugs on a Chevrolet 1992 Beretta, 3.1 L automatic trnsmission located? 8 answers

Location of spark plugs on a 3.1L engine for a 1992 Chevrolet Beretta?

1992 Chevrolet Beretta

-

Maintenance & Repair
96 Beretta wont start 1 answer

!996 Beretta 3.1 V6. Engine quit on a hot day in traffic. Then after it cooled it ran fine. Then months later would not start. Replaced 4 of the plugs and wires, the crankshaft sensor, the throttle po...

1996 Chevrolet Beretta 2 Dr STD Coupe

-

Maintenance & Repair
i have a 1991 3.1L beretta and i can't find the starter, where is it? 4 answers

my haynes book doesn't say where it is...only how to take it out and i cant find it anywhere on my own

1991 Chevrolet Beretta

-

Maintenance & Repair
waterleak when engine is warm 1 answer

water leak in engine compartment whem engine is hot

1993 Chevrolet Beretta 2 Dr GT Coupe

-

Maintenance & Repair
Oil Pressure 4 answers

For the 3.1 SFI what is the normal oil pressure?

Chevrolet Beretta

-

General