Why does my 1993 Mazda MX-6 only start (after it stalls which it rarely does) when I disconnect the electric harness to the distributor for 5 - 10 seconds and then reconnect?

0

Asked by PerplexedInHouston Feb 11, 2013 at 02:02 PM about the 1993 Mazda MX-6 2 Dr STD Coupe

Question type: Maintenance & Repair

how do i disarm the anti-theft system 3 answers

The anti-theft system is not working properly and my car will not start? How can I disarm the anti-theft system and get my car to start?

1995 Mazda MX-6 2 Dr STD Coupe

-

Maintenance & Repair
need help setting the tining on my 1992 mazda miata 6 answers

need help stting the timing on my 1992 mazda miata. i just changed the water pump and now i need help to set the timing.

1992 Mazda MX-5 Miata 2 Dr STD Convertible

-

Maintenance & Repair
engine will not shut down with the key in off position 2 answers

Engine will not shut down with the key in the off position (disconnected the battery to shut it down and reconnected) . Battery run down when not running . I have changed the ignition switch and it...

1996 Mazda Millenia 4 Dr L Sedan

-

Maintenance & Repair
how to reset the check engine light 7 answers

How do you reset the check engine light on a Mazda Mellenia 2002?

2002 Mazda Millenia 4 Dr S Supercharged Sedan

-

Maintenance & Repair
what happening when the car wants to turn over but wont start 3 answers

I found out what part of the problem was that the previous person to whom work on it last reconnect fulelines backwards so at this point its wanting to start as but wont stay started if you let go i...

Mazda RX-7

-

Maintenance & Repair