my 1996 voyager chrysler is having some problems,2 plugs and one side of ignition coil is working,what can i do

0

Asked by brostenal Jul 16, 2012 at 08:25 AM about the Chevrolet Volt

Question type: Maintenance & Repair

995

- Report

Tom answered 10 months ago

replace the coil

Mark helpful

6,985

- Report

John answered 10 months ago

And then the coil will blow up again the computer is shot I have seen this twice. Both times the side of the coil looked like it blew up. I replaced the first one and it still ran rough and within a day the coil had a crack in the side. I found out from a Chrysler guy that its common and the computer was shot. I replaced it and the coil again and it was fine. About a month later another one did it, both times it was crazy hot out the heat index was 105+. All I'm saying is find out first have a certifiedelectronics tech look at it. There is a procedure

Mark helpful

Your Answer

2010 Volt 5 answers

How much will the 2010 Chevrolet volt cost? What will the tax incentive amount be? Will the 'redundant' electrical systems for the power hungry climate control system, radio, wipers, etc. run off the ...

Chevrolet Volt

-

Shopping & Pricing
What do you think of the 2010 Chevrolet Volt? 17 answers

What is so great about this car? Have you ever driven one?

Chevrolet Volt

-

General
My Chevy Lumina will not start hot, runs/idles rough 96 answers

I have a 1996 Chevy Lumina LS, 3.1 V6. Over the last 18 months I have had problems with it getting hot (not engine coolant) and not starting after driving for a while or running a few errands of 10-20...

1996 Chevrolet Lumina 4 Dr LS Sedan

-

Maintenance & Repair
See below 11 answers

I inherited a 76 monza with a missing ignition coil. I installed a new coil, but they cut the connector and took it with them. There are 4 spade terminals on the coil. 2 on the right and 2 on the left...

1976 Chevrolet Monza

-

Maintenance & Repair
I need the side panels for the extended cab on my 1996 Chevy S-10. Where can I find them? 1 answer

Rust has taken the best portion of the lower part of both sides of the panels on the extended cab portion of my 1996 Chevy S-10. A person who looked at it thought I should try to replace the panels i...

1996 Chevrolet S-10 2 Dr LS Extended Cab SB

-

Maintenance & Repair