- Home /
- Questions /
- Chevrolet /
- Blazer /
- how do i remove a free spinning fan clutch from an old water pump being replaced? the old pump is ou...
how do i remove a free spinning fan clutch from an old water pump being replaced? the old pump is out with the fan and clutch still attached.
1 Answer
lightGear answered 5 years ago
Did you figure out how to remove it? You may want to get a Chilton or Haynes manual to help you through the process.
Your Answer
Related Questions
-
How can i replace the parts if the shop always need a sample? 5 answers
The old engine fan was missing when I bought this car from the old owner and it is only using electrical auxillairy fan attached to the radiator, thus when the AC is turned on the temperature gauge g...
1996 Chevrolet Blazer 4 Dr LS 4WD SUV
-
Maintenance & Repair
-
i have a 2001 chevy blazer it stopped running i dont have any power to fuel pump i switched the relay in fuse box under the hood still no power 3 answers
2001 Chevrolet Blazer 2 Dr LS 4WD SUV
-
Maintenance & Repair
-
How can I get the front axles out the hub bearing assembly, I've removed the axle nut and rented a hub puller and applied heat to it, but it is seized in there and will not come out. 3 answers
Iv'e removed the axle nut, attached the hub puller, and applied heat to it, also I hit on it with a 3lb. hammer, this thing is seized in there and wont come out. I need it out so I can get to the lo...
2000 Chevrolet Blazer 4 Dr LT 4WD SUV
-
Maintenance & Repair
-
How do you remove the left front wheel hub assembly, 1 answer
2000 Chevrolet Blazer 4 Dr LT 4WD SUV
-
Maintenance & Repair
-
my heater stopped blowing hot air 4 answers
1996 Chevrolet Blazer 2 Dr LS 4WD SUV
-
General
Shortcuts
Search Chevrolet Blazer Questions
Chevrolet Blazer Experts
| #1 |
|
bovan
Reputation
250
|
| #2 |
|
lightGear
Reputation
210
|
| #3 |
|
judge_roy
Reputation
200
|