Transmission trouble in reverse

0

Asked by swamp1 May 01, 2012 at 01:15 PM about the 1986 Jeep Comanche

Question type: Maintenance & Repair

When put in reverse, you almost have to have the engine at 1/2 to 3/4 throttle to get it to move! The trans works great in forward gears.

3,125

- Report

dodgecummins answered about a year ago

Your trans might be low on fuid or your tans might be going bad and might have to relplace it.

1 out of 1 people think this is helpful.

Mark helpful

65

- Report

jayjay101 answered about a year ago

reverse or first go sone one after the other if fluid is up your trany is gone

1 out of 1 people think this is helpful.

Mark helpful

Your Answer

won't go in reverse....only forward 3 answers

jeep won't move in reverse

1994 Jeep Grand Cherokee

-

Maintenance & Repair
when putting the transmission into Reverse, a terrible, loud, gear crunching noise happens 2 answers

when putting the transmission into Reverse, a terrible, loud, gear crunching noise happens

2010 Jeep Grand Cherokee

-

Maintenance & Repair
reverse 3 answers

my jeep shifts into reverse but doesnt move, drive and everything else works fine

2000 Jeep Grand Cherokee Laredo

-

Maintenance & Repair
Jeep grand cherokee, 2004..no reverse 2 answers

Car was seeming to run fine. Went into a store for about 30 min. When I came out and started my car it would not go in reverse. Can hear it spinning, but will not back up.

2004 Jeep Grand Cherokee Laredo 4WD

-

Maintenance & Repair
transmission 2 answers

I'm having trouble getting my manual transmission saab into reverse. My 1999 saab barely has 100,000 miles. It's been a headache. This problem seems major to me. Any advice? Thanks.

1999 Saab 9-3 4 Dr Turbo Hatchback

-

Maintenance & Repair