96 chevy s10 engine turns ,but no fire

classylady0157
0

Asked by classylady0157 May 16, 2011 at 08:00 AM about the 1996 Chevrolet S-10

Question type: Maintenance & Repair

2 Answers

Peter Nichols
1,805

replace the crankshaft position sensor , thats where i'd start looking

1 out of 1 people think this is helpful.
Burton Lane
305

check for spark at spark plug end of wires. if good, go to fuel system checks. if no, check for spark from coil. if okay, replace cap, rotor and wires, perhaps plugs. if no, it could be the coil. check for power on the + side and a ground signal on the - side while cranking. if okay, suspect coil. if no, suspect crank sensor or distributor/ignition module. if ignition checks okay, check for fuel pressure. if no, suspect fuel pump/filter. if okay, check for power and ground signal to injectors while cranking. if no, suspect cam sensor/possible pcm. if okay, try cranking with pedal pressed fully to the floor. this is "clear-flood mode". if the vehicle now starts, suspect mass air flow sensor. if no, you may have a mechanical issue or a bad injection module.

2 out of 2 people think this is helpful.

Your Answer

Related Questions

Search Chevrolet S-10 Questions

Chevrolet S-10 Experts

#1 Andrew Olsen
Andrew Olsen
Reputation 650
#2 John Saffrahn
John Saffrahn
Reputation 380
#3 bovan
bovan
Reputation 370
View All