I have a 2000 Montana it is over heating how do you bleed the air out of the motor?

0

Asked by fig_1962 Nov 29, 2012 at 08:50 PM about the 2000 Pontiac Montana

Question type: Maintenance & Repair

7,165

- Report

John answered 5 months ago

If its the 3.4l there is a little bleed valve on top of the steel tube that is located on the water pump housing. Have you had work done to it recently? Only reason air would get into the system is if lots of coolant was lost either by working on it or a hole. When does it overheat?

Mark helpful

7,165

- Report

John answered 5 months ago

Do not open that valve if the engine is already warned up.

Mark helpful

Your Answer

All but 3 vents blow cold air w/ AC on 4 answers

I have a '99 Pontiac Montana w/ 100K miles. Within the last week, the 3 left dash vents (driver's side left of steering wheel and the center and left of the 3 center cluster vents do not blow cold air...

1999 Pontiac Montana 4 Dr STD Passenger Van Extended

-

Maintenance & Repair
2002 montana won't start 4 answers

120000 miles

2002 Pontiac Montana

-

Maintenance & Repair
2001 Montana - What should be the length of the passenger's windshield wiper? 2 answers

I've had this problem for a while where my wipers catch on each other and then get twisted. I've tried adjusting their off position with no luck. I just changed the whole assembly thinking the motor o...

2001 Pontiac Montana Base Extended

-

Maintenance & Repair
2004 Montana hesitates breifly at cruising speeds feel like a stall 6 answers

from time to time while cruising at about100km hr the veh will jerk as tho it had stalled ...just momentarily and infrequent

2004 Pontiac Montana

-

Maintenance & Repair
fan not blowing heat out 1 answer

When I turn the heat on in my car, it does not blow out any air, why is this?

2001 Pontiac Grand Am SE

-

Maintenance & Repair