My C10 69 gas gauge doesn't work right, one day is full tank and the next day is like 3/4. Any ideas?

0

Asked by cisco_paco Feb 26, 2012 at 01:15 AM about the 1969 Chevrolet C10

Question type: Maintenance & Repair

15

- Report

Nathan answered about a year ago

check your wire to the sending unit? Maybe it has a bad connection somewhere along the way?

Mark helpful

0

- Report

69chevyman answered about a year ago

If sending unit wire checks out then could be float inside tank, they are known too corrode and or get stuck after years of use. I had a similar problem with my 69. Problem solved with new float. Good Luck!!

Mark helpful

Your Answer

truck not turning over 2 answers

I just bought a '68 c10 and it was running fine no problems, when I went to start it up the other day it had been left with the ignition left in on all the lights worked in the cab and exterior. i gue...

1968 Chevrolet C10

-

Maintenance & Repair
I have a 66 C10 with a 350 with a radiator mounted fan but no fan blades on the motor pully is this enough air for the cooling? 9 answers

just bought this truck and it ran great untill lately it seems when the engine gets to running temp or after about 5 miles or so the engine starts to run and idle ruff any ideas?

1966 Chevrolet C10

-

Maintenance & Repair
Recently my auto transmission has become difficult to shift back into park. Any ideas... 4 answers

1972 Chevrolet C10

-

Maintenance & Repair
Fuel Tank 6 answers

I have 1972 c10 with 1989 stepside bed installed. I'm a 350/350,650 Holley,12 bolt rearend 373 gears. I want to use the existing fuel door on the stepside, whta fuel tank should I use with the mechani...

1972 Chevrolet C10

-

Car Customization
How much should I ask for a 1970 C10, if only good for parts? 1 answer

Truck will run with a little work, but in pretty bad condition. Been sitting for awhile and has a lot of rust. Someone has asked to buy it for the parts, but I have no idea how much it is worth...

1970 Chevrolet C10

-

General